Then clean the area around the disk to remove dust and anything else that might scratch vehicle’s paint during removal.ģ. First remove the antenna from the disk.Ģ. Just be aware that antenna location will result in decreased performance from your booster system. You can mount the antenna on a vehicle’s trunk lid, rather than the roof, if you choose. Then remove the white film from the disk and place the antenna on it. Remove the clear film and press the disk in place on the vehicle in the location you’ve chosen.ģ. Make sure the antenna will be at least 12 inches from any other antennas and at least 6 inches from any glass, including windows and sunroof.Ģ. Clean the area on vehicle where you want to place the antenna. ![]() ![]() Installing the disk is a breeze and takes only a couple of minutes. The disk can also hold an antenna on a fiberglass-bodied vehicle, but you would need to provide a metal ground plane for the antenna to work properly. The double-sided adhesive disk adheres to aluminum vehicles and firmly holds the antenna in place. The weBoost solution is an adhesive disc, which now comes in the box for those booster kits that include a magnetic antenna. ![]() This method just takes a few minutes, and best of all, unlike an NMO antenna, the installation is NOT permanent. Installation involves drilling a hole in the vehicle roof or trunk lid.įortunately now there is an easy option from weBoost for installing a magnetic antenna to aluminum-body vehicles. NMO antennas work very well, but they have a trade-off. There is always the NMO (Non-Magnetic Option) antenna. Here’s a question for you: If you’re installing a cell booster in your vehicle, and it has an aluminum body, how do you install the outside antenna? The antenna is magnetic, but it won’t stick to a vehicle with a body made of non-ferrous material.
0 Comments
Leave a Reply. |